TX-WL102

Small RF ASK Sender

This sender breakout board enables you to send data on the designated frequency. This is a 3.3V board. You cannot operate it with 5V.

This sender is often sold as a kit together with the receiver RX470-4 or WL101-341.

Technical Data

Item Value
Voltage 2.0-3.6V
Frequency 433MHz or 315MHz
Output Power >11dBm / >12.5mW
Operating Current <6mA
Modulation Mode AM (OOK)
Transmission Rate <20 Kbps
Distance 20-100m
Size 16x12x1mm

Pins

The board comes with four pins labeled on the back side.

Pin Description
- negative voltage/GND
+ 2.0-4.6V
DAT data in
EN enable pin, not connected

Antenna

The antenna needs to be soldered to the solder pad marked TUO.

Always operate senders with an antenna. If no designated antenna is at hand, use a plain 17.3cm wire for 433MHz, and a 23.8cm wire for 315MHz.

See Also

Documentation

Slow Website?

This website is typically very fast, and pages should appear instantly. If this site is very slow for you, then your routing may be messed up, and this issue does not only affect done.land, but potentially a few other websites and downloads as well. Here are simple steps to speed up your Internet experience and fix issues with slow websites and downloads..

Comments

Please do leave comments below. I am using utteran.ce, an open-source and ad-free light-weight commenting system.

Here is how your comments are stored

Whenever you leave a comment, a new github issue is created on your behalf.

  • All comments become trackable issues in the Github Issues section, and I (and you) can follow up on them.

  • There is no third-party provider, no disrupting ads, and everything remains transparent inside github.

Github Users Yes, Spammers No

To keep spammers out and comments attributable, all you do is log in using your (free) github account and grant utteranc.es the permission to submit issues on your behalf.

If you don’t have a github account yet, go get yourself one - it’s free and simple.

If for any reason you do not feel comfortable with letting the commenting system submit issues for you, then visit Github Issues directly, i.e. by clicking the red button Submit Issue at the bottom of each page, and submit your issue manually. You control everything.

Discussions

For chit-chat and quick questions, feel free to visit and participate in Discussions. They work much like classic forums or bulletin boards. Just keep in mind: your valued input isn’t equally well trackable there.

  Show on Github    Submit Issue

(content created Apr 18, 2024)